Replacing, Developer unit – Panasonic Panafax UF-750 User Manual
Page 121
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MFiTT"-
Replacing
the
Developer Unit
When the developer unit is aged, replace with a new one. The Maintenance Report
lets
you
verify whether the developer unit is aged or not (see page 106). To change
the
drum unit, follow these procedures.
1
.
First, turn off the power. Open the front cover and lift the clamshell release lever
to raise the clamshell.
2. Loosen the fixing screw and remove the drum unit. Then remove the developer unit.
Fixing Screw (Green)
Drum Unit
3. Install a new developer unit, (see pages 10-12). Then reinstall the drum unit into
the machine while lifting it by its handle.
Take care not to touch the yellow drum
surface,
(see page
12)
4. Tighten the fixing screw of the drum unit. Then lower the clamshell until it is locked
and close the front cover.
CAUTION
If the power is turned off when the MEMORY LED is ON, document information stored
in memory will be erased.
NOT€
Clean the inside of the machine either before or after installing a new developer unit,
(see page 122).
118