0 infrared window, Code set, 0 input selector buttons – Yamaha HTR-5950 User Manual
Page 10: 0 sound field program selector buttons, 0 speakers, 0 enhancer, 0 level, Sound field program descriptions, Remote control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS AND FUNCTIONS
Remote control
This section describes the function of each control on the remote control used to control this unit. To operate other
components, see "REMOTE CONTROL FEATURES” on page 90.
Notes
•
The XM Satellite Radio conlrolliiig functions in the following buttons (XM, XM MEMORY, SRCH MODE, DISPLAY, cursor
buttons /\ / sy / < / X niiineric buttons anti ENT) arc only applicable to the U.S.A. model and are operational only when ”XM" is
selected as the input source. For details, see *'XM Satellite Radio controls and functions" on page
53.
•
The operation mode of the remote control buttons in the shaded area below depends on the component selector switch position. Set the
component selector switch to AMP to control this unit. To control the TUNER functions, set the component selector switch to
SOURCE and then press TUNER to select ‘TUNER” as the iitput source,
■ Controlling this unit
”S1jr
Set the component selector switch to AMP to control this
unit.
0
Infrared window
Outputs infrared control signals. Aim this window at the
component you want to operate (see page 8).
@ CODE SET
Use to set up remote control codes (see page 92).
0
Input selector buttons
Select the input source you want to control.
Note
The corresponding input selector button for the currently selected
input source lights up for approximately 5 seconds after you press
any buttons on the remote control, showing which source
component is currently being operated.
0
Sound field program selector buttons
Select sound field programs (see page 63).
- Use SELECT to play back 2-channel sources in
surround (.see page 42).
- Use EXTD SUR. to switch between 5.1 and
6.1-channel playback of multi-channel sources
(see page 41).
- Use DIRECT ST. to play back 2-channel sources in
hi-fi stereo sound (see page 38).
0
SPEAKERS
Turns on or off the set of front speakers connected to the
FRONT A and/or B terminals on the rear panel. Press this
button repeatedly to toggle as follows:
r->
A on
B on
A and B off
0
ENHANCER
Turns on or off the Compressed Music Enhancer mode
(see page 36).
0
LEVEL
Selects the speaker channel to be adjusted and sets the
output level (see page 35).