Troubleshooting – Yamaha HTR-5950 User Manual
Page 102
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or
if
the instruction below does not help, set this unit to the standby mode, disconnect the power cable, and contact the
nearest authorized YAMAHA dealer or service center.
■ General
Problem
Cause
Remedy
See
page
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
The power cable is not connected or the
plug is not completely inserted.
Connect the power cable firmly.
—
The speaker impedance setting is
incorrect.
Set the speaker impedance to match your speakers.
26
The protection circuitry lias been
activated.
Make sure that all speaker wire connections on this
unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective eonncctioii.
13
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
—
No sound
Incorrect input or output cable
connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
18-2.3
“INPUT MODE” is sel lo “DTS” or
“ANALOG”.
Set “INPUT MODE” to “AUTO”.
34
No appropriate input source has been
selected.
Select an appropriate input source with the INPUT
selector on the front panel (or the input selector
huitons on the remote control) and MULTI CH
INPUT on the front panel (or MULTI CH IN on the
remote control).
31,37
Speaker connections are not secure.
Secure the connections.
13
The Iront speakers to be used have not
been selected properly.
Select the set of front speakers with SPEAKERS A or
B on the front panel or SPEAKERS on the remote
control.
31
The voliiine is turned down.
Turn tip the volume.
—
The sound is muted.
Press MUTE or VOLUME +/- on the remote control
to resume audio output and then adjust die volume.
33
"IN.PUT MODE” is set to "ANALOG”
while playing a source encoded in DTS.
Sc) “INPUT MODE” to “AUTO” or “DTS”.
34
Signals this unit cannot reproduce arc
being input from a source component.
such as a CD-ROM.
Play a source whose signals can be reproduced by this
unit.
—
No picture
The output and input for the picture are
connected to different types of video
jacks.
Set “VIDEO CONV.” to “ON”.
85
98