Yamaha HTR-5950 - Manual (Page 98)

REMOTE CONTROL FEATURES
■ Setting remote control XM ID library
codes (U.S.A. model only)
Select one of the following codes to set the remote control
XM ID library code for the component you want to use.
1 Press XM to select “XM” as the input source.
2 Press CODE SET using a ballpoint pen or a
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
Resetting all remote control codes
Use this feature to clear all the remote control codes
previously set and reset all of them to the initial factory
settings.
1 Press CODE SET using a ballpoint pen or a
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
TRANSMIT
;o;:
Flashes
TRANSMIT
Flashes
Press the numeric buttons to enter the code
number “81918” or “81919”.
The TRANSMIT indicator on the remote control
flashes twice, and the XM ID library code is changed.
. STÉriEÓ- .• 'M!JSR; ENTEK’IAIN
• ■pTA.J-IDAIili-u'liE LEA:T '. :EXTp: s’UIi.
srrAKmsliHiwurTR:
• Tor
l'IREtTil.':
Í
IjivtUT .• .fiTRAKMHT'- 1
lii
TRáNSyiT
Flashes
XM ID
library code
‘1
Function
Remote
control XM
ID '2
SiniS li' ilij^ unii loiiig
(iiiilial setting) the default code.
A .
(initial setting)
81919
To operale this unit using
an alternative code.
ID2
The remote control setting
1 The setting of this unit (see page 89)
Notes
You need lo scl the corresponding remote control XM ID
of this unit in the advanced setup (sec page 89).
When using multiple YAMAHA rcccivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes lo operate this unit
separately.
Press the numeric buttons to enter the code
number “9981”.
The TRANSMIT indicator on the remote control
flashe.s twice, and all the remote control codes
previously set are cleared and reset to the initial
factory settings.
ENtERTAIN "MóviE'.
.r'-/ ■ ■ ■ ■ ■ ■■
VIANUARD SELECT
iiA.i;.
■■
EXiD íJUR. : [iJHEbTST.
■Ty V
íMiínrns- . rNHAHÍilIk
- • -A
■ ■ '"V...............
FFF.rRT ;
TRANSMIT
Flashes
If you do not press any bultons within 30 seconds alter step
2, the clearing process is canceled. In this case, repeat the
clettring procedure.
94