Yamaha HTR-5950 - Manual (Page 96)

REMOTE CONTROL FEATURES
Setting the remote control code
You can control your TV and other components by setting
the appropriate remote control code for each input source.
For a complete list of available remote control codes, refer
to “LIST OF REMOTE CONTROL CODES” at the end of
this manual.
The following table shows the default component in the
“Library (component category)” colutnii and the remote
control code for each input source.
Remote Control Code Default Settings
InpLit
source
Libritry
(component
category)
Manufacturer
Default
code
CD CD YAMAHA 61907
MD/CD-R MD YAMAHA 70888
XM TUNER YAMAHA 81918
DVD DVD YAMAHA 403.39
DTV/CBL - - -
TUNER TUNER YAMAHA 81916
V-AUX - - -
DVR DVR YAMAHA 51544
* - - -
- - -
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try setting other YAMAHA remote control codes.
1 Press one of the input selector buttons or
☆ /** to select the component you want to
set up.
"■'■y
t.:i:i-i{). : ; XM i-..
. . HiiiTi.iiHiH '
( tun .Y-.
2 Press CODE SET using a ballpoint pen or a
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
Flashes
Press the numeric buttons (0 to 9) to enter
the five-digit remote control code for the
component to be used.
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component i.s .set.
STEricO- ■ :filL'filU :: EllTEHtAlN- .MOVIE
(i; 1 ■)V' ■( i/‘V- . ( a ').: ■; f 4.'
A. ..r. ■. ■■ .\ „a a ..¡y
STAflbAFiL'- SELECT iEETUSOFI.- [llHEcr Sll!
d':' !, ). ■. ■( t, / );.■.( u
.mHiiNciih
{■« A
NIY-HT-. '.S'lRAKiMT':
(■; ioi- ■ ffflt;;.
.• .• ..FFHiOr .,
Flashes
Refer to “LIST OF REMOTE CONTROL CODES” at the
eird of this manual.
Notes
• If the marmfacturcr of your component has more than one
code, try each of them until you find the correct one.
• If you do not press any buttons within .fO seconds in step
3. the setup process is canceled. If this happens, repeat the
setup procedure.
• If you ether the code number “9980”, the remote control
code previously set for the selected component is cleared.
92