Using video features, Signal format l-uf<mflt, Sampling frequency sl lilflihi – Yamaha HTR-5950 User Manual
Page 43: Channel (iihijr-ihllel, Bit rate l:::!l3"|2m"re, Displaying the input source information, Cf o
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING VIDEO FEATURES
Displaying the input source
information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Set the component selector switch to AMP
and then press SET MENU on the remote
control.
The top “SET MENU” display appears in the OSD.
m
cf
o
i
SET MENU
I
MENU.
SRCH MODi
2
Press V repeatedly to select “SIGNAL INFO”
and then press ENTER.
The following information about the input source
appears in the OSD.
Signal format l-uf<MflT
Signal format display. When this unit cannot detect a
digital signal, it automatically switches to analog
input.
Display status: Analog, Digital, Dolby D, DTS, PCM,
Note
"—“ appears wheji this unit cannot detect any signals.
Sampling frequency Sl lilFLIHi::!
The number of samples per second taken from a
continuous signal to make a discrete signal.
Display status: 32kHz, 44.1kHz, 48kHz, 64kHz,
88.2kHz, 96kHz, —
Note
"—” appears when this unit cannot detect the sampling
frequency.
Channel (iiHijr-ihllEL
The number of source channels in the input signal
(front/surround/LFE). Eor example, a multi-channel
soundtrack with 3 front channels, 2 surround
channels and LEE, is displayed as “3/2/0.1”.
Note
■'—” appears when there is no source chainiel available.
Bit rate l:::!l3"|2M"rE;
The number of bits passing a given point per second.
Note
“—” appears when this unit cannot detect the bit rate.
Flag F'!.J4(::i
Flag data encoded in DTS. Dolby Digital, or PCM
signals that cue this unit to automatically switch
decoders.
3
Press SET MENU on the remote control again
to exit from “SET MENU”.
SETtilEHU
[ MENI
SRCH MODi
39