Panasonic DVDL50D - Manual (Page 3)

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
A
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL,
A
The lightning flash with arrowhead symbol, within an equilateral tri­
angle, is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and mainte­
nance (servicing) instructions in the literature accompanying the ap­
pliance.
FCC NOTE: (U.S.A. Only)
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protec­
tion against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the in­
structions, may cause harmful interfer­
ence
to radio communications.
However, there is no guarantee that in­
terference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or
television reception, which can be de­
termined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving an­
tenna,
• Increase the separation between the
equipment and receiver.
•Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
•Consult the dealer or an experienced
radio/TV technician for help.
FCC Caution: To assure continued
compliance, follow the attached instal­
lation instructions and use only shield­
ed cables when connecting to other
devices. Also, any changes or modifi­
cations not expressly approved by the
party responsible for compliance could
void the user’s authority to operate this
equipment.