Panasonic KXFLM600NZ - Manual (Page 3)

For Australian users
Warning;
•This equipment will be inoperable when mains power fails.
•When*a failure occurs which results in the internal parts becoming accessible,disconnect the power
supply cord immediately and return this unit to an authorized service center.
•Disconnect the telephone connection before disconnecting power connection prior to relocating the
equipment,and reconnect the power first.
•To minimize the possibility of lightning damage, when you know that a thunderstorm is coming, we
recommend that you:
A. Unplug the telephone line cord from the phone jack.
B. Unplug the power supply cord from the AC power outlet.
• No “000” or other calls can be made from this device during a mains power failure.
For New Zealand users
Warning:
•WHEN A FAILURE OCCURS WHICH RESULTS IN THE INTERNAL PARTS BECOMING
ACCESSIBLE, DISCONNECT THE POWER SUPPLY CORD IMMEDIATELY AND RETURN THIS
UNIT TO AN AUTHORIZED SERVICE CENTER,
• DISCONNECT THE TELECOM CONNECTION BEFORE DISCONNECTING THE POWER
CONNECTION PRIOR TO RELOCATING THE EQUIPMENT, AND RECONNECT THE POWER FIRST.
• NO "111” OR OTHER CALLS CAN BE MADE FROM THIS DEVICE DURING A MAINS POWER
FAILURE.
IMPORTANT NOTICE
Under power failure conditions, this telephone may not operate. Please ensure that a separate telephone,
not dependent on local power, is available for emergency use.
Notice;
•The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does its provide any sort of warranty. Above all, it provides
no assurance that any item will work correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply that any product is compatible with all of
Telecom’s network services.
•This device is equipped with pulse dialling while the Telecom standard is DTMF tone dialling. There is
no guarantee that Telecom lines will always continue to support pulse dialling.
• Use of pulse dialling, when this equipment is connected to the same line as other equipment, may give
rise to bell tinkle or noise and may also cause a false answer condition. Should such problems occur,
the user should NOT contact Telecom Faults Service.
•This equipment shall not be set to make automatic calls to the Telecom “111” Emergency Service.
•This equipment should not be used under any circumstances which may constitute a nuisance to other
Telecom customers.
•This equipment may not provide for the effective hand-over of a call to another device connected to the
same line.
• Not all telephones will respond to incoming ringing when connected to the extension socket.
•The Message Center Software used with facsimile unit should be set in compliance with Telecom’s PTC
specification.
The software must be set within the following limits in order to ensure compliance with Telecom’s
requirements:
1. Do not set the number of retries to more than 9.
2. Do not set the retry interval to less than 25 seconds.
3. Do not select pulse dialling.
Note that failure to set these parameters correctly may negate the user’s rights under Telecom’s Terms
of Service.