360 Systems RC-220 Remote Controls - Manual (Page 14)

RC-205/210/220 Remote Control Owner's Manual Second Edition March 1997 Page
12
RC-210 Remote Control —
Play Only
The RC-210 Remote Control is designed expressly for on-air playback
operations. It provides rapid access to Cuts and Stacks while preventing
accidental loss of material. You cannot access any destructive functions for
the DigiCart using the RC-210 Remote Control.
You can build and play Quickstacks using the MAKE PLAYLIST key.
You can access up to 16 Presets for instant playback of Cuts or Linear
Stacks.
FIND operations are available by ID number on the numeric keypad. The
STACK DIR key gives instant access to the Stack Directory.
Connecting the RC-210 to Your DigiCart
The RC-210 Remote Control models uses the Serial Port 2 connector on
the rear panel of the DigiCart. Use the interconnect cable that came with
your RC-210 to connect it to the DigiCart.
DC power for the Remote Control is supplied from a small wall-mount
transformer. Notice that this transformer should be plugged into AC power
near the DigiCart end of the cable. At the Remote Control end, plug the
small male DC power connector on the cable into the DC power input on the
rear panel of the Remote Control.
For cable runs longer than 25 feet (8 meters), you should connect the DC
transformer directly into the rear panel of the Remote Control. This
prevents problems resulting from voltage drops or current loss over a long
cable run.