360 Systems RC-220 Remote Controls - Manual (Page 5)

RC-205/210/220 Remote Control Owner's Manual Second Edition March 1997 Page 3
The RC-205 allows easy titling and renaming chores as well as other
functions that deal with alpha and numeric finding of cuts and stacks. It
works very nicely along with the RC-210 or RC-220 in creating an excellent
human interface to the DigiCart; in fact, this three-way access to audio
information makes for optimum convenience and efficiency in operations.
Note: Early versions of DigiCart and DigiCart/II firmware do not employ the F5 key for
the FIND function. On these units, access to the FIND function is available by
holding the FN key and pressing the "+" key (show in blue letters on the front
side of the ": ;" key) — located in the second row of keys.
ARROW KEY FUNCTIONS
The cursor keys on the RC-205 duplicate the SELECT KNOB and
POSITION ARROWS on the front panel of the DigiCart.
• The UP and DOWN arrows duplicate the functions of the
SELECT KNOB on the DigiCart.
• The RIGHT and LEFT arrows duplicate the functions of the
POSITION ARROWS on the DigiCart.
FIND OPERATIONS
Using the RC-205, you can readily FIND any Cut or Stack by Name or Index
number.
TO FIND BY INDEX
1. Press the FIND key (F5).
2. The DigiCart screen will display:
FIND (Blinking Cursor)
HH:MM:SS
48K AC-2
Note: The information on the bottom line pertains to
the current Selection.
3. Enter the Index number for the Cut or Stack you wish to
locate. Press the "S" key to indicate Stack Directory.
4. Press ENTER.