360 Systems RC-220 Remote Controls - Manual (Page 16)

RC-205/210/220 Remote Control Owner's Manual Second Edition March 1997 Page
14
ARROW KEY FUNCTIONS
The cursor keys in the upper right had corner of the RC-210 duplicate
the SELECT KNOB and POSITION ARROWS on the front panel of
the DigiCart.
• The UP and DOWN arrows duplicate the functions of the
SELECT KNOB on the DigiCart.
• The RIGHT and LEFT arrows duplicate the functions of the
POSITION ARROWS on the DigiCart.
FIND OPERATIONS
By using the numeric keypad, you can instantly Find any Cut or Stack by its
Index number. Cuts in the current directory only require entry of their Cut
number. For Cuts in other Directories, use the full four-number Identifier.
For Cuts on other Drives, use the full five-number identifier. The " . "
separator is provided automatically.
TO FIND A CUT
1. Enter the first digit of the Index number for the Cut you wish
to locate.
Note: You do not need to press any special key to initiate the Find
process. Once you press any key on the numeric keypad, the
Remote Control assumes you wish to Find a Cut.
2. The Remote Control screen will display:
FIND CUT (Blinking Cursor)
HH:MM:SS
48K AC-2
Note: The information on the bottom line pertains to
the current Selection.
3. Complete the entry of the Index number for the Cut you wish
to locate.
4. Press ENTER.