360 Systems RC-220 Remote Controls - Manual (Page 25)

RC-205/210/220 Remote Control Owner's Manual Second Edition March 1997 Page
23
FIND OPERATIONS
By using the numeric keypad, you can instantly Find any Cut or Stack by its
Index number. Cuts in the current directory only require entry of their Cut
number. For Cuts in other Directories, use the full four-number Identifier.
For Cuts on other Drives, use the full five-number identifier. The " . "
separator is provided automatically.
TO FIND A CUT
1. Enter the first digit of the Index number for the Cut you wish
to locate.
Note: You do not need to press any special key to initiate the Find
process. Once you press any key on the numeric keypad, the
Remote Control assumes you wish to Find a Cut.
2. The Remote Control screen will display:
FIND CUT (Blinking Cursor)
HH:MM:SS
48K AC-2
Note: The information on the bottom line pertains to
the current Selection.
3. Complete the entry of the Index number for the Cut you wish
to locate.
4. Press ENTER.
5. DigiCart will instantly cue up to the Index number you
entered. Press PLAY to Play the Cut or enter it into a Stack
(see "Make Playlist" below.)
Note: For Cuts in the current Directory, you only need to enter the
last three digits of the Index. For Cuts in other Directories, use
the last four digits of the Index.
For Cuts on the current Drive, only enter the last four digits of
the Index. For Cuts on other Drives, use the full five-number
Index.
The " . " separator is not needed with the FIND function.
6. Repeat as necessary for Follow-On Play or press CANCEL
to exit.