360 Systems RC-220 Remote Controls - Manual (Page 27)

RC-205/210/220 Remote Control Owner's Manual Second Edition March 1997 Page
25
PRESET OPERATIONS
The PRESET function lets you assign a Cut or Linear Stack to the 16
PRESET buttons on the RC-220. When assigned, the selection will PLAY
immediately when you press the associated Hot Key, or PRESET.
The terms Hot Key and PRESET are used interchangeably in this manual.
There are certain important conditions that apply when working with
PRESETS:
• All Cuts (and Cuts contained in Stacks) assigned to
PRESETS must be recorded in the Dolby AC-2 format.
• All Cuts (and Cuts contained in Stacks) assigned to
PRESETS must be stored on the hard disk.
• PRESETS are subject to the currently selected RESTART
MODE under the SETUP MENU— IMMEDIATE or ON
COMPLETION.
ASSIGNING PRESETS
1. Press the ASSIGN PRESET button on the Remote Control.
The display will show:
X.XXXX (Name)
SELECT PRESET
Note: The information on the top line refers to the
currently selected Cut or Stack.
2. SELECT or FIND a Cut or Linear Stack on the hard disk.
3. Press the PRESET key you wish to assign. (At this point a
message appears briefly on display: "Machine 01 not on
line". This message is of no consequence.)
Note: It is not necessary to Clear a PRESET before reassigning it.
4. Repeat steps 2 and 3 as necessary.