Rear connectors, Setting up and starting the analog rytm – Elektron Analog Rytm User Manual
Page 13
PANEL LAYOUT AND CONNECTORS
5
REAR CONNECTORS
The Analog Rytm Rear Connectors.
1.
Power On/Off switch.
2.
Power In (12V DC 2A). Use the included PSU-3 power adapter, or equivalent, connected to a power outlet.
3.
Full-speed USB 2.0. Connect to a computer host using the included A to B USB 2.0 connector cable.
4.
MIDI Thru. Use standard MIDI cable to connect another MIDI unit in chain. Duplicates incoming MIDI In
data stream. Can also be configured to send DIN sync to legacy instruments.
5.
MIDI Out. Use standard MIDI cable to connect to MIDI In of an external MIDI unit. Can also be configured
to send DIN sync to legacy instruments.
6.
MIDI In. Use standard MIDI cable to connect MIDI Out of an external MIDI unit in order for it to control the
Analog Rytm.
7.
Individual drum voice outputs CY/CB - RS/CP, CH/OH - MT/HT, SD - LT and BD - BT. Use 1/4” insert/Y
cable in order to access both voices of each output.
8.
Audio In. Use 1/4” stereo (Tip/Ring/Sleeve) phone plug to input stereo sound from an external source.
9.
Main Out L/R. Use either 1/4” mono phone plug (unbalanced connection) or 1/4” (Tip/Ring/Sleeve) phone
plug (balanced connection).
10. Headphones Out. Connect standard headphones with 1/4” stereo phone plug.
SETTING UP AND STARTING THE ANALOG RYTM
Make sure you place the Analog Rytm on a stable support, such as a sturdy table with sufficient cable space or
mount on a rack capable of a 3 kg load.
1.
Before you connect the Analog Rytm to other equipment, make sure all units are switched off.
2.
Plug the included PSU-3 adapter to a power outlet and insert the small plug into the Analog Rytm Power In.
3.
Connect the Main Out L/R from the Analog Rytm to your mixer or amplifier.
4.
If MIDI control is desired, connect the MIDI OUT port of the device you wish send data from to the MIDI IN
port of the Analog Rytm. The MIDI THRU port duplicates the data arriving at the MIDI IN port. It is used for
chaining several MIDI units together.
5.
Switch on all units. Switch on the Analog Rytm by pressing the Power rocker switch located at the back of
the unit. Before restarting the unit, wait 2 seconds after the LCD backlight goes out.