Elektron Analog Rytm - Manual (Page 61)

GLOBAL MENU
53
OUTPUT CH selects whether the [PADS] and the knobs will send data on the auto channel or
the track channel.
PARAM OUTPUT selects what type of MIDI messages the DATA ENTRY knobs will send. For
information about which CC/NRPN parameters that will be sent, please see “Appendix C:
MIDI“.
• NRPN will make the knobs send out NRPN MIDI messages.
• CC will make the knobs send out CC MIDI messages.
ENCODER DEST controls whether the DATA ENTRY and LEVEL knobs will send MIDI data
or not. When set to INT, no MIDI data will be sent.
PAD DEST controls whether the [PADS] will send MIDI data or not. When set to INT, no MIDI
data will be sent.
PRESSURE DEST controls whether varying pressure applied to the [PADS] will send MIDI
data or not. When set to INT, no MIDI data will be sent.
MUTE DEST controls whether activating/deactivating mutes will send MIDI data or not. When
set to INT, no MIDI data will be sent.
RECEIVE NOTES will, when active, make it possible to play Analog Rytm using an external
MIDI keyboard.
RECEIVE CC/NRPN will when active make it possible to control Analog Rytm parameters
from an external MIDI device sending CC/NRPN data.
MIDI CHANNELS
This menu handles the MIDI channel configuration.
TRACK 1-12, FX selects dedicated MIDI tracks that will control the drum and FX tracks. An
OFF setting will make the track disregard any incoming MIDI messages.
PERF CHANNEL selects the MIDI channel the knobs will send MIDI data on when PERFOR-
MANCE mode is active.
AUTO CHANNEL selects the MIDI channel that will give access to the currently active track. If
an external MIDI keyboard connected to Analog Rytm sends MIDI data on this channel, the
keyboard will control the active track. This is useful when for example quickly changing
between the active drum tracks to play different Sounds.
PROGRAM CHANGE IN CHANNEL selects the MIDI channel that will listen for incoming pro-
gram change messages. An AUTO setting will use the AUTO channel. Enable Analog Rytm to
respond to program change messages in the MIDI SYNC menu, covered on page 51.
PROGRAM CHANGE OUT CHANNEL selects the MIDI channel that will send program
change messages when changing patterns. An AUTO setting will use the AUTO channel.
Enable Analog Rytm to send program change messages in the MIDI SYNC menu, covered on
page 51.