Elektron Analog Rytm - Manual (Page 67)

EARLY STARTUP MENU
59
EARLY STARTUP MENU
To access this menu, hold down the [FUNCTION] key while powering up Analog Rytm. From here you can per-
form a variety of tasks. To choose the different alternatives, press the corresponding [TRIG] key.
TEST MODE
To enter this mode, press the first [TRIG] key.
• Warning: For testing purposes, a short loud beep is heard through all outputs of the unit.
If you have any trouble with your Analog Rytm and suspect it may be due to a hardware problem, perform this
self test. No errors should be reported as shown below. If that is not the case, contact Elektron support or the
retailer you bought Analog Rytm from.The [UP] and [DOWN] keys can be used to scroll through the test log.
EMPTY RESET
To perform this operation, press the second [TRIG] key. All kits, patterns, Sounds and songs will be erased. The
+Drive remains intact.
FACTORY RESET
When performing a factory reset on the Analog Rytm it will overwrite and re-initialize the active RAM project
(including all pattern, kit, sound pool and global data). The +Drive project slot 1 will be overwritten and re-initial-
ized with factory preset patterns, kits, Sounds and settings. Sound bank A will be overwritten with the factory
Sounds.
If you wish to keep the active project, remember to save it to a +Drive project slot higher than 1 before you per-
form a factory reset. To perform a factory reset, press the third [TRIG] key.
OS UPGRADE
Initiate the OS upgrade by pressing the fourth [TRIG] key. Analog Rytm will enter a waiting stage, listening for
incoming OS data, and “READY TO RECEIVE” will be shown on the LCD screen. For the transfer to be possi-
ble, the device sending the OS syx-file should be connected to the MIDI IN port of Analog Rytm. To send the OS
syx file, use our free SysEx utility software C6. The OS syx file and the C6 software can be downloaded from the
Elektron website.