Elektron Analog Rytm - Manual (Page 3)

WARNING
To reduce the risk of fire, electrical shock or product damage:
•
Do not expose the unit to rain, moisture, dripping or splashing and also avoid placing objects filled with liquid, such as vases, on the
unit.
•
Do not expose the unit to direct sunlight, nor use it in ambient temperatures exceeding 30°C as this can lead to malfunction.
•
Do not open the casing. There are no user repairable or adjustable parts inside. Leave service and repairs to trained service tech-
nicians only.
SOUND PEAKS
•
A brief 3 kHz signal will be sent to all outs of the Analog Rytm when the Test mode on the Early Startup menu is activated. Remem-
ber to turn down the volume on all speakers and headphones before activating Test mode.
•
During calibration there will be loud and unpleasant sounds on the individual outs. Disconnect these during calibration.
SAFETY INSTRUCTIONS FOR THE POWER ADAPTER ELEKTRON PSU-3
•
The adapter is not safety grounded and may only be used indoors.
•
To ensure good ventilation for the adapter, do not place it in tight spaces. To prevent risk of electric shock and fire because of over-
heating, ensure that curtains and other objects do not prevent adapter ventilation.
•
Do not expose the power adapter to direct sunlight, nor use it in ambient temperatures exceeding 40°C.
•
Connect the adapter to an easily accessible electrical outlet close to the unit.
•
The adapter is in standby mode when the power cord is connected. The primary circuit is always active as long as the cord is con-
nected to the power outlet. Pull out the power cord to completely disconnect the adapter
.
•
In the EU, only use CE approved power cords.
IMPORTANT SAFETY AND MAINTENANCE INSTRUCTIONS
Read these instructions and follow them.
1. Do not use this unit near water.
2. Never use aggressive cleaners on the casing or on the LCD
screen. Remove dust, dirt and fingerprints with a soft, dry
and non-abrasive cloth. More persistent dirt can be removed
with a slightly damp cloth using only water. Disconnect all
cables while doing this. Only reconnect them when the prod-
uct is safely dry.
3. To avoid scratches or damage, never use sharp objects near
the casing or the LCD screen. Avoid applying any pressure
to the screen itself.
4. Install in accordance with the manufacturer’s instructions.
Make sure you place the unit on a stable surface before use.
If you mount the unit in a rack, be sure to tighten all four
screws in the rack mount holes.
5. Connect the unit to an easily accessible electrical outlet
close to the unit.
6. When transporting the unit, use accessories recommended
by the manufacturer or the original box and padding.
7. Do not install near any heat sources such as radiators, heat
registers, stoves, or any other equipment (including amplifi-
ers) producing heat.
8. Do not put the PL-2 Protective Cover (Elektron accessory)
on the unit while the unit is powered on.
9. Do not block the ventilation holes located on the side and the
bottom of the enclosure of the unit. Make sure there is suffi-
cient air circulation in the room where the unit is kept.
10. This product, by itself or in combination with amplifiers,
headphones or speakers, is capable of producing sound lev-
els that may cause permanent hearing loss. Do not operate
at a high volume level or at a level that is uncomfortable.
11. Protect the power cord from being walked on or pinched par-
ticularly at plugs, convenience receptacles, and the point
where they exit from the unit.
12. Use attachments/accessories specified by the manufacturer.
13. Unplug this unit during lightning storms or when it is not used
for long periods of time.
14. Refer all servicing to qualified service technicians. Servicing
is required when the unit has been damaged in any way, liq-
uid has been spilled or objects have fallen into the unit, the
unit has been exposed to rain or moisture, does not operate
normally, or has been dropped.