Elektron Analog Rytm - Manual (Page 28)

KITS AND SOUNDS
20
RELOAD KIT will reload either the active kit, reverting it to its saved status, or all kits. Using the [LEFT] and
[RIGHT] keys selects whether only the active kit or all kits will be reloaded. [NO/RELOAD] + [KIT] offers a
shortcut to reloading the active kit.
LOAD KIT opens a menu where one of the up to 128 saved kits can be loaded. When this menu is accessed the
kit list will appear. The active kit is shown with inverted graphics. Select the kit to be loaded by using the
[ARROW] keys or the LEVEL knob. [LEFT]/[RIGHT] will quickly scroll between the menu pages. Once a kit has
been selected, press [YES/SAVE] to load it. The loaded kit will be linked to the active pattern. If the active kit is
loaded, it will be reloaded to the state it was saved in.
SAVE KIT saves all the current kit related settings as a kit. When a kit is saved, it will be linked to the active pat-
tern. [YES/SAVE] + [FX] offers a shortcut to this command, saving the kit instantly to the same slot and with the
name of the kit unchanged. It is good practice to use the shortcut frequently to ensure kit changes are saved.
When this menu is opened the kit list will appear. The active kit is shown with inverted graphics. Select the slot
to which the kit will be saved by using the [ARROW] keys or the LEVEL knob. Press [YES/SAVE] to save to the
selected slot. The NAMING screen, covered on page 10, will appear.
CLEAR KIT will clear the content of the currently loaded kit, basically initializing it. When selecting this option a
prompt will appear. Press [YES/SAVE] to clear the kit or [NO/RELOAD] to cancel the operation. Note that no kit
information will be permanently lost until the kit is saved to the same kit slot it was loaded from.
TRACK ROUTING highlight this item, found at the very bottom position of the KIT menu, and press [YES/SAVE]
to customize track routing. The default setting is to use the TRACK ROUTING global settings found in the
GLOBAL menu. See section “GLOBAL MENU” on page 48.
If you want custom settings for the currently active kit, press [YES/SAVE] to untick the USE GLOBAL SETTING
box and to open the complete ROUTING menu. Use [ARROW] keys [UP] and [DOWN] to highlight one of the
three options.
USE GLOBAL SETTING press [YES/SAVE] if you decide to use GLOBAL settings after all.
The <PADS> will show what the current GLOBAL settings are for the drum tracks. <PADS> of
a green color send to main. Unlit <PADS> do not.
ROUTE TO MAIN highlight this option to customize which of the 12 tracks will send to the
master effects (Distortion and Compressor) and main output. Use the [PADS] to activate/
deactivate send from the track of each corresponding pad. <PADS> of a green color send to
main. Unlit <PADS> do not. Note that each track will still send to its individual output.
ROUTE TO FX highlight this option to customize the send FX routing of the 12 tracks. Use the
[PADS] to activate/deactivate each corresponding track for sending to the send FX (Delay and
Reverb). <PADS> of a yellow color send to FX. Unlit <PADS> do not.