Clear track, Pattern copy, Clear track -53 pattern copy -53 – Elektron Monomachine User Manual
Page 61
THE PATTERN SEQUENCER
53
CLEAR TRACK
While in GRID RECORDING mode, it is possible to clear a track.
1.
Make sure you are in GRID RECORDING mode. The <RECORD> LED should be lit.
2.
When you are on the track you wish to clear, press and hold [FUNCTION]. Then press
[PLAY] to clear the track. The message “CLEAR TRACK” will appear.
•
The clear track operation can be undone by performing the clear track operation
one more time. The message “UNDO TRACK” will be shown in the display.
PATTERN COPY
To copy the contents of a pattern to another pattern location, follow the steps below.
1.
Make sure that the <RECORD> LED is not lit, so you are not in GRID RECORDING
mode.
2.
Select the source pattern by using the [BANK] and [TRIG] keys. Hold [FUNCTION] and
then press [REC]. A message “COPY PATTERN” will be shown in the display.
3.
Choose the pattern where you wish to paste your pattern data.
4.
Paste the data by holding [FUNCTION] and then pressing the [STOP] key. A message
“PASTE PATTERN” will be shown in the display.
•
Pasting data into a pattern overwrites any previous data in the pattern.
•
The pattern data that is copied consists of notes, parameter locks, the kit associa-
tion, MIDI sequencer notes and arpeggiato, transpose, swing and slide settings
for all six tracks.