Elektron Monomachine - Manual (Page 92)

MONOMACHINE ROUTING
84
machine in NEIBOR mode to the track after, and all the track effects of the second
track will be applied after the first one. Just remember to turn off the outputs of
the first track.
• NEIBOR mode is good for quick FX routing, when no more than one track need to
be fed into the FX.
MIX BUS ROUTING
For applying an effect to two or more mixed tracks you need to use the mix buses as input
for the FX machine. To use this mode, set track number two or higher to use an FX
machine, and set INPUT to “BUS XX”, where XX is the mix bus AB, CD or EF.
When the output of a track in the Monomachine is set to AB, CD or EF, it is fed to one of the
three mix buses, which by default ends in the audio outputs with the same names. The
tracks are mixed in the same order as their index, with track 1 first.
The contents of the mix bus can be used as input for the FX machines. If the same bus is
used for input and output, the FX is applied as an insert effect. If another bus is used to out-
put the FX output is mixed into the track normally, just like synthesis machines.
In the example above all tracks but the third is assigned to the AB mix bus. Track 5 is a FX
machine, with INPUT and OUTPUT set to MIX AB. As the output is the same as the input
the FX is applied as an insert effect. What will happen is that track 1, 2 and 4 will be mixed
and effected by track 5. The output of the effect will then be mixed with track 6 and sent to
the AB outputs. Track 3 is sent by itself to the EF outputs, non-effected.
4:/5)&4*4
4:/5)&4*4
4:/5)&4*4
4:/5)&4*4
4:/5)&4*4
'9
#64
"#
5'9
5'9
5'9
5'9
5'9
5'9
.*9 .*9 .*9