Elektron Monomachine - Manual (Page 91)

MONOMACHINE ROUTING
83
• All track effects, the LFO’s and the sequencer are still at your hands when using
the audio inputs! Set up six tracks with various track effect settings, LFO settings
and use the sequencer on top of this, and you have a unique and powerful effects
processor.
• The output of the tracks always pass through the track effects, of which the ampli-
fier envelope is part. If you want the audio to pass through without decaying you
need to set DEC and REL to their maximum levels (127) and retrig the machine.
NEIGHBOUR ROUTING
The FX machines can also take their inputs from internal synthesis sound of the Monoma-
chine. One of the modes for this is the NEIBOR mode. To use this mode, set track number
two or higher to use an FX machine, and set INPUT to NEIBOR.
In NEIBOR mode, the output of the previous track is used directly, and fed into the input of
the FX machine of the current track. Only the input of one track is used for the input, but
NEIBOR FX machines can be chained.
In the example above all audio outputs are set to the main AB mix bus. Track 2 and 6 is
routed to FX machines set to NEIBOR mode, and the input is taken directly from the previ-
ous track. All outputs are turned off for track 2 and 5.
• Use the neighbour FX to get access to an additional track effect! If you rather want
the distortion to be applied after all other effects, you can assign a THRU FX
4:/5)&4*4
4:/5)&4*4
'9
/&*()#063
4:/5)&4*4
4:/5)&4*4
'9
/&*()#063
5'9
5'9
5'9
5'9
5'9
5'9
.*9 .*9 .*9