Acura 2007 RL - Owner's Manual - Manual (Page 176)

When you are pressing the ignition
switch, or when the ignition switch is
in the ON (II) position, the beeper
sounds if you take the remote out of
the vehicle and close the door. To remove the ignition switch cover,
insert the built-in key (see page
),
then pull the cover out by pulling the
built-in key while pushing it.
Also, if you close the door when the
ignition switch is not in the LOCK
(0) position and the remote is not
inside the vehicle, the keyless access
alarm sounds outside the vehicle, a
message appears on the multi-
information display, and the beeper
sounds if the ignition switch is in the
ON (II) position.
When the beeper sounds after you
close the driver’s door outside the
vehicle, check the position of the
ignition switch and the location of
the remote.
If the engine is running and you
remove the remote from the vehicle,
it will continue to run. But once
turned to the LOCK (0) position, the
engine will not restart until a remote
is brought back into the vehicle. 177
Keyless Access System
Beeper and Message Removing the Ignition Switch
Cover
Keyless Remote Not Detected
174
BUILT-IN KEY
IGNITION SWITCH COVER
push
pull
Main Menu Table of Contents