Acura 2007 RL - Owner's Manual - Manual (Page 67)

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. This indicator has three functions:
It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page
).
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page
.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should flash.
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
If it comes on and stays on at any
other time, or it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. You
will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page ).
Take your vehicle to a dealer to have
it checked. Without VSA, your
vehicle still has normal driving ability,
but will not have VSA traction and
stability enhancement. For more
information, see page .
1.
2.
3.
78
78
371
371
371
406
Instrument Panel Indicators
Vehicle Stability Assist
(VSA) System Indicator VSA Activation Indicator Turn Signal and
Hazard Warning
Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
65
Main Menu Table of Contents