Kenmore 808353 - Manual (Page 41)

3 Remove upper pump housing (diffuser) Í3)
4 Remove upper impeller, macerator blade, spacer plate, and pump plate (41
5 Remove lower impeller and seals Í5)
6 Detach motor and pump housing assembly cover, and gaskets from tub ¡8 screws) ( 6 )
7 Remove pump housing from motor (4 thru-bolts at base of motor or 4 short bolts at top of bell housing) and
mark position of pump housing in relation to motor
8 Install housing in same position on replacement motor IMPORTANT! The motor shaft musí be accuratefy
centered in the pump housing for Draper operamn of the pump To assure precise centering, we J^oo/
803923 as litusireted in Figure 2T, before tightening thru bolts (Available through Sears Parts Departmem.)
9 After the pump housing has been secured to replacement
ber of shim washers to be used between the lower impeller and the motor shatl bnims are requirea io insure
rnrrpri merino oressure of the water seals To determine the number of shims recjuired, hold shim gauge
{furnished with kit) firmly on surface of pump housing as shown in Figure 37 (Note: Shim gauge should not be
on top of gasket ¡
The shim washers are 1/32 inch thick. Fill the space between the motor shaft and shim gauge with the shims
CAUTION: .
Do not over shim by allowing the gauge to raise above the pump housing surface.
3 8