Kenmore 808353 - Manual (Page 89)

PROBLEM
POSSIBLE CAUSE
ACTIOW
Dishwasher omits portion
o1 B selected wash cycle
1. Damaged or defective timer switch or
cams inside timer case.
2. Open circuit between selector switch and
timer, (Rapid advance timer orrlyj
3. Defective electrical comporient.
1 R e f e r t o timer testing
2, Refer to wiring diagram and trace
circuit for power loss.
3., Check component associated with
mtssed portion of cycSe.
Dishwasher performs
part of the cycle at
incorrect times.
4, Pinion gear slipping on rapid advance
motor shaft,
1. Lead wires connected to incorrect
timer terminals-
2, Selector switch improperly wired.
4, Replace timer. Applies to dishwashers
with rapid advance timer
1, Refer to wiring diagram for correct
connections,
2. Refer to wiring diagram for correct
connections.
3, Pinion gear slipping on rapid advance *
motor shaft,
4, Damaged or defective selector switch.
3. Replace timer. Applies to dishwashers
with rapid advance timers.
4, Check selector switch per wiring
diagram.
Dishwasher stops part
way through a cycle.
1. Cycle selector button is not fully
depressed,
2. Wires disconnEcted at the selector
switch terminals,
3. Open circuit inside the selector switch
4. Timer damaged or switches making and
breaking at wrong time..
1, Refer to Owners Manual on proper way
to USB dishwasher,
2. Reconnect wires--
3, Refer to selector switch circuitry on
wiring diagram and check continuity-
4, Refer to wiring diagram and cycle
chart Check all timer switches for
correct length of time each should be
dosed.
Stuck in portion of the
cycle, (Timer will not
advarrce 1
1. Open circuit to motor,
2 Wire disconnected at heater.
3. Thermostat contacts not closing to
start timer motor after water reaches
temperature in the delay (sani) periods.
4. Open circuit or damaged selector switch.
1. Refer to wiring diagram and check
this circuit.
2. Reconnect wire-
3. Check thermostat.
4, Refer to wiring diagram and check
circuitry of selector switch.
5, Defective timer motor.
5, Check if power to timer motor, if
timer motor has power and is rotating,
the timer is defective.
8 6