Comtrol IOLM 4-EIP - Manual (Page 19)

IO-Link Master 4-EIP User Guide: 2000582 Rev. A Chapter 3. Initial Configuration - 19
Using the Web Interface
9. You wait until PortVision DX polls to display the updated IO-Link Master IP address or you can click
Refresh until the new IP address is displayed in the Device List pane.
10. If you want to configure any of the following options, go to 3.2. Using the Web Interface on Page 19:
- Host name
- DNS servers
- Syslog Server IP/Host name
- Syslog Port
- SSH Server Enable
You are ready to configure the ports, refer to Chapter 5. IO-Link Port Configuration on Page 31.
3.2. Using the Web Interface
This subsection discusses using the web interface to configure the IP address.
Note: The rotary switch settings override the lower 3 digits (8 bits) of static IP address configured on the
Configuration/Network page. The default rotary switch setting uses the settings configured in the flash.
Optionally, you can use the web interface to configure the upper 9 digits (24 bits) and the rotary switch
to configure the lower 3 digits (8 bits) of the static IP address. You can also refer to
2.1. Setting the
Rotary Switch on Page 7 for additional information.
You can use the following procedure to configure the IO-Link Master network settings if you have
administrative rights.
1. Open the IO-Link Master web interface using one of these method:
• From PortVision DX, highlight the IO-Link Master and click the Webpage button or right-click the IO-
Link Master in the Device List pane (lower pane) and click Webpage.
• Open your browser and enter the IP address of the IO-Link Master.
Note: The default IP address is 192.168.1.250.
2. Click Configuration and then NETWORK.