Comtrol IOLM 4-EIP - Manual (Page 43)

IO-Link Master 4-EIP User Guide: 2000582 Rev. A Chapter 5. IO-Link Port Configuration - 43
Modbus/TCP Settings Parameters
Event Active Hold Time
Default: 1000 ms
If Clear Event Code After Hold Time is enabled, the time period an
event code is reported in the PDI block before it is cleared.
Valid range: 1-65535
Valid Units are:
• ms (milliseconds)
• sec (seconds)
• min (minutes)
• hours
• days
Clear Event Hold Time
Default: 500 ms
Once an event code has been cleared, the time an event code stays
cleared in the PDI block before another event code can be reported.
• Valid range: 1-65535
• Valid Units:
• ms (milliseconds)
• sec (seconds)
• min (minutes)
• hours
• days
Transfer Mode Settings
Slave Mode Device ID
Default: 1
The Modbus Device ID used to access this IO-Link port.
Range: 1-247
PDI Receive Mode(s)
Default: Slave
Determines which PDI Receive (To PLC) Modes are enabled.
The selectable modes is Slave.
Note: Not selecting slave mode disables Modbus/TCP access to the
PDI data block.
PDO Transmit Mode
Default: Slave
Selectable Modes are:
• Disabled
• Slave
Modbus/TCP Settings Page (Continued)