Using portvision dx to update software – Comtrol IOLM 4-EIP User Manual
Page 27
Advertising
IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Chapter 4. Updating Images and Application Subassemblies - 27
Using PortVision DX to Update Software
4.2. Using PortVision DX to Update Software
Use the following procedure to update software (images or application subassemblies) on the IO-Link Master.
1.
If necessary, start PortVision DX.
2.
Right-click the IO-Link Master that you want to update and click Advanced and then Upload Firmware.
3.
Browse to the location you saved the software, highlight the file name, and click Open.
4.
Click Yes to the Upload Firmware... Important Notice.
5.
Click Ok to the Upload Firmware... Status message.
Advertising