Using the web interface to update software, Updating images – Comtrol IOLM 4-EIP User Manual
Page 28
28 -
Chapter 4. Updating Images and Application Subassemblies
IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Using the Web Interface to Update Software
You may notice that PortVision DX first displays a Firmware uploaded status message. After the next
PortVision DX polling cycle the status message displays ON-LINE.
4.3. Using the Web Interface to Update Software
The upper portion of this page is used to update the IO-Link Master images. The lower portion of this page is
used for updating application subassemblies that are integrated in the Application Base. Typically, the latest
application subassemblies are available in the Application Base image. There may times when a feature
enhancement or bug fix is available in an application subassembly and not yet available in the Application
Base image.
4.3.1. Updating Images
Use this procedure to upload images using the SOFTWARE page.
1.
Download the latest image from the Comtrol ftp site.
2.
Open the IO-Link Master web interface using one of these methods:
•
From PortVision DX, highlight the IO-Link Master and click the Webpage button or right-click the IO-
Link Master in the Device List pane and click Webpage.
•
Open your browser and enter the IP address of the IO-Link Master.
3.
Click ADVANCED and SOFTWARE.
4.
Click the UPDATE button next to the image you want to update.
5.
Click the Browse button (or Choose File, depending on the web browser), navigate to the file location,
highlight the image file, and click Open.