Security, Port security – Comtrol ES8510-XTE User Manual
Page 103
RocketLinx ES8510-XTE User Guide: 2000574 Rev. C
Security - 103
Configuration Using the Web Interface
Security
The ES8510-XTE provides several security features for you to secure your connection. The following pages are
included in this group:
•
•
•
•
•
Optionally, you can use the CLI for configuration, see
Port Security
The Port Security page allows you to stop the MAC address learning for specific port. After stopping MAC
learning, only the MAC address listed in Port Security List can access the switch and transmit/receive traffic.
You can restrict what devices can access the ES8510-XTE
management features. MAC addresses added to the static
MAC address table can be authorized to access specified
ports on the switch.
When Port Security is enabled on any port, only
authorized MAC addresses are able to access the
management features of the ES8510-XTE on enabled
ports. Ports with security disabled block all attempts to
access the ES8510-XTE’s management features. To
globally disable port security you must disable the
feature on each individual port.
The Port Security page allows you to enable port security
and configure a port security entry list.
Port Security Page
Port Security State Select Enable to change the state of the Port Security State for this port.
Apply
Click Apply to apply the settings.
Note: You must Save the settings (
), if you want to maintain these
settings if the ES8510-XTE is powered off.
Add Port Security
Entry
Select the port, and enter the VID and MAC address.
The format of the MAC address is xxxx.xxxx.xxxx, for example: 00c0.4e30.0101.
The maximum volume of one port is 10. The system can accept a total of 100 Port
Security MAC addresses.
Add
Adds a port security entry.
Port Security List
This table shows you enabled port security entries.
Remove
Removes the selected port security entry.