Comtrol ES8510-XTE - Manual (Page 9)

RocketLinx ES8510-XTE User Guide: 2000574 Rev. C Hardware Installation - 9
Hardware Installation
You can use the following subsections to install the RocketLinx ES8510-XTE:
• Connect the Power and Ground
• Connect the Digital Input s and Relay Outputs on Page 10
• Mount the ES8510-XTE on Page 11
• Connect the Ethernet Ports on Page 12
• Connect SFP Transceivers (Combo Ports 8-10) on Page 12
• LED Descriptions on Page 13
• Panel Layout on Page 14
• Reset Button on Page 14
Connect the Power and Ground
You can use the following procedure to connect power and the ground to the ES8510-XTE.
1. Connect the DC power inputs.
a. Insert positive and negative wires (12-24AWG) into the PW+ and PW- contacts.
Note: Power should be disconnected from the power supply before connecting it to the switch.
Otherwise, your screw driver blade can inadvertently short your terminal connections to the
grounded enclosure.
AC Power Input
AC Power Input
Power Supply
10 - 60VDC
(UL Listed)
Power Supply
10 - 60VDC
(UL Listed)
V-
V+
V-
V+
12 - 24AWG Wire
12 - 24AWG Wire
Wiring Power Supplies
Positive and negative power system inputs are both accepted, but PW1 and
PW2 must be applied in the same mode.