Comtrol ES8510-XTE - Manual (Page 174)

174 - Warnings (CLI) RocketLinx ES8510-XTE User Guide: 2000574 Rev. C
Configuration Using the Command Line Interface (CLI)
Warnings (CLI)
The ES8510-XTE provides several types of warning features for you to remotely monitor the status of the
attached devices or changes in your network. The features include Fault Relay, System Log, and SMTP Email
Alert.
Optionally, you can use the web user interface for configuration, see Warning on Page 109.
This table provides detailed information about the command lines of the warning configuration.
Fault Relay Output
Relay Output
Switch(config)# relay 1
di DI State
dry dry output
ping ping failure
port port link failure
power power failure
ring super ring failure
Note: Select Relay 1 or 2 first and then the event types
DI State
Switch(config)# relay 1 di
<1-2> DI number
Switch(config)# relay 1 di 1
high high is abnormal
low low is abnormal
Switch(config)# relay 1 di 1 high
Dry Output
Switch(config)# relay 1 dry
<0-4294967295> turn on period in second
Switch(config)# relay 1 dry 5
<0-4294967295> turn off period in second
Switch(config)# relay 1 dry 5 5
Ping Failure
Switch(config)# relay 1 ping 192.168.250.33
<cr>
reset reset a device
Switch(config)# relay 1 ping 192.168.250.33 reset
<1-65535> reset time
Switch(config)# relay 1 ping 192.168.250.33 reset 60
<0-65535> hold time to retry
Switch(config)# relay 1 ping 192.168.250.33 reset 60 60
Port Link Failure
Switch(config)# relay 1 port
PORTLIST port list
Switch(config)# relay 1 port fa1-5
Power Failure
Switch(config)# relay 1 power
<1-2> power id
Switch(config)# relay 1 power 1
Switch(config)# relay 1 power 2
Super Ring Failure Switch(config)# relay 1 ring
Disable Relay
Switch(config)# no relay
<1-2> relay id
Switch(config)# no relay 1 (Relay_ID: 1 or 2)
<cr>