Futaba 6J 2.4GHz - Manual (Page 20)

20
Model type HELI: Parameters- Data Reset / Model Type Select /Mode Select/Throttle Cut/Battery Fail
Safe/Model /name, Model Select, Reversing, Dual Rates, Exponentials, End Point Adjustments, Trim, Sub-
Trim, Normal Throttle Curve, Normal Pitch Curve, Idle Up Throttle Curve , Idle Up Pitch Curve, Throttle
Hold, Throttle Hold Pitch Curve, Revolution Mixing, Gyro Sensitivity, Swash-Throttle Mixing, Swash Ring,
Swash/AFR, Delay, Hovering Pitch, Failsafe, Trainer, and Timer.
The SELECT key will be used to view the settings, scroll through the options, etc. within the respective
function. When a data change is actually required the DATA INPUT lever will be used to increase or
decrease the value of the item displayed, thus making the change. The DATA INPUT lever, in some cases,
may also be used to scroll through the various options and adjustments.
You can return to the home screen (where model name and battery voltage is displayed) by depressing and
holding the END key for approximately one second.
Note: The functions are listed and described in the order that they appear in the transmitter. Read all the way
WKURXJK WKH SURJUDPPLQJ LQVWUXFWLRQV EHIRUH VHWWLQJ XS \RXU PRGHO LI \RX ZRQ¶W EH XVLQJ DQ\ RI WKH PL[LQJ
IXQFWLRQV IRU D ZKLOH \RX FDQ UHDG WKRVH LQVWUXFWLRQV ZKHQ UHDG\  5HIHU WR WKH IXQFWLRQ ÀRZ FKDUW RQ SDJH
(ACRO).
Parameter (PARA)-
7KH 7-¶V SDUDPHWHU PHQX LWHP DOORZV IRU D YDULHW\ RI SURJUDPPLQJ DQG IXQFWLRQDOLW\
This includes model reset, aircraft type selection, mode selection, throttle cut and the battery fail safe
selections.
Model Select Function (MODL)-
The model select function (MODL) is used to select amongst existing models or to create entirely new
PRGHOV LQ WKH 7-¶V PRGHO PHPRU\ <RX FDQ VWRUH XS WR  GLIIHUHQW PRGHOV LQ WKH 7- ,Q RUGHU WR DYRLG
confusion, or inadvertently altering a model memory for a different aircraft, we strongly suggest naming each
model immediately after it is selected. To do so, please refer to the Model Name section of this manual.
To select model memory:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode. An audible
double beep will be heard and the default screen will change.
3) Press either the MODE key OR the END key to scroll through the function menus. Continue pressing the
MODE or END key until the model select function appears on the LCD screen- MODL. The number of the