Futaba 6J 2.4GHz - Manual (Page 35)

35
and the neutral position of the servos will shift. Keep in mind that you should start out with the control
VXUIDFHV FHQWHUHG ZKHQ WKH VHUYRV DUH FHQWHUHG DQG WKH WULPV DUH ³]HURHG´ RU QHDU ]HUR  7+(1 \RX FDQ
adjust the trims once airborne.
Each of the trim levers features an audible tone, or beep, that alerts you when the trim is activated.
Additionally, there is a double-beep and a slight pause that occurs when the trim lever is centered (zeroed).
$GMXVWLQJ WKH WULPV ZLWK WKH WULP OHYHUV FKDQJHV WKH VHUYR¶V SRVLWLRQ LQ LQFUHPHQWV RI ³´ ,I ILQHU
adjustments are required, land the model and then enter the program as described below to adjust the trims in
LQFUHPHQWV RI ³´ 7KLV ¿QHU DGMXVWPHQW ZLOO DOORZ IRU D PRUH SUHFLVH ÀLJKW RI WKH PRGHO
Note: :KHQ WKH WUDQVPLWWHU LV SRZHUHG GRZQ RU WXUQHG RII WKH WULP YDOXHV DUH VWRUHG LQ WKH WUDQVPLWWHU¶V
PHPRU\ 'HSHQGLQJ XSRQ WKH ZLQG FRQGLWLRQV HWF LW PLJKW EH QHFHVVDU\ WR ¿QHWXQH WKH WULPV VOLJKWO\
however, it is not necessary to start from the beginning.
Center the servos:
1) Turn on the transmitter and receiver. Operate the controls to make sure the servos respond in the correct
direction. Use the reversing function to reverse any servos necessary.
2) Center the throttle control stick.
3) Place the servo arms on the servos so they are perpendicular to the pushrods (see page ?? ). It is okay to
cut off any unused servo arms.
4) Connect the pushrods to the control surfaces. Adjust the length of the pushrods until the control surfaces
are centered when the servos are centered.
7R ¿QHWXQH WKH WULP VHWWLQJV
Once the servos and control surfaces have been connected and the control throws have been set using the end
SRLQWV DQG GXDO UDWHV JHW WKH PRGHO DLUERUQH $GMXVW WKH WULPV DV QHFHVVDU\ WR JHW WKH PRGHO WR À\ VWUDLJKW
and level.
1) If the transmitter is off, turn it on at this time.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the trim (TRIM) menu appears on
screen.
 3UHVV WKH 6(/(&7 NH\ WR GLVSOD\ WKH FKDQQHO WR EH DGMXVWHG WKH ¿JXUH VKRZV WULP