Futaba 6J 2.4GHz - Manual (Page 32)

32
GRZQ LV LQGLFDWHG E\ WKH ÀDVKLQJ DUURZ DERYH RU EHORZ WKH FKDQQHO LQGLFDWRU
2) Observing the up/down switch position indicator, change the dual rate value for the respective channel
using the DATA INPUT lever until the desired control throw is achieved.
Again, if the arrow is pointing upward, the rate is being adjusted for the up position of the switch.
*HQHUDOO\ SLORWV SUHIHU WR KDYH WKH VZLWFK LQ WKH ³XS´ SRVLWLRQ IRU WKH KLJK UDWH DQG LQ WKH ³GRZQ´ SRVLWLRQ
for the low rate.
3) Press the SELECT key to change the switch position indicator to the opposite position.
Note: This assumes that the modeler has adjusted the up switch position. If the down switch position was
adjusted, the SELECT key will move to the next channel or switch selection menu as the case may be.
4) Change the dual rate value for the respective channel using the DATA INPUT lever until the desired
control throw is achieved.
5) Repeat the procedure for the remaining channels and switch positions as desired.
6) Press and hold the END button to save these settings and exit the programming menu.
Exponential Settings (EXPO) - HELI
Exponential, or EXPO as it is commonly abbreviated, affects the travel of the servos around their center in
relationship to stick movement. Exponential does NOT impact the overall travel volume of the servos. A
SRVLWLYH H[SRQHQWLDO ³´ LQFUHDVHV WKH VHQVLWLYLW\ QHDU WKH FHQWHU QHXWUDO VWLFN SRVLWLRQ 7KXV WKH KLJKHU
WKH SRVLWLYH SHUFHQWDJH YDOXH WKH PRUH VHQVLWLYH WKH JLYHQ FKDQQHO ZLOO EH QHDU WKH VWLFN¶V QHXWUDO SRVLWLRQ
&RQYHUVHO\ D QHJDWLYH ³³ H[SRQHQWLDO LQSXW ZLOO VRIWHQ RU UHGXFH WKH VHUYR V PRYHPHQW V QHDU WKH FRQWURO¶V
neutral position.
The T6J transmitter offers exponential adjustments for the ailerons, elevator and rudder channels. The EXPO
settings are controlled by the switch that has been selected for the dual rates (D/R). As with the dual rates
settings, the exponentials are also simultaneously activated.
7KH DPRXQW RI WUDYHO GHFUHDVH IRU HDFK FRQWURO PD\ EH VHW EHWZHHQ  DQG  RI WKH YDOXHV VHW IRU
the end points (explained in End Point Adjustment on page ?? ).
To set the exponentials:
1) Turn the transmitter on.