Futaba 6J 2.4GHz - Manual (Page 45)

45
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the throttle curve (T-CV) menu
appears on screen.
4) The right side of the LCD should indicate that the throttle curve is inhibited, as
GHQRWHG E\ WKH ÀDVKLQJ ,1+ $FWLYDWH WKH WKURWWOH FXUYH E\ SUHVVLQJ DQG KROGLQJ
WKH '$7$ ,1387 OHYHU XSZDUG 7KH ,1+ VKRXOG EHJLQ ÀDVKLQJ UDSLGO\ SULRU WR
changing to ON.
5) Press the SELECT button six (6) times to bring up the (SW) switch selection
options.
Note: it is possible to assign the throttle curve operation to any of the switches on the T6J.
6) Press the DATA INPUT lever upward or downward to select the desired switch for the throttle curve that
will be programmed below.
Note: Prior to adjusting the throttle curve points, ensure that the switch is in the desired position (up or
down).
To set the throttle curve (T-CV):
1) From the activation channel selection screen above, press the SELECT button two
(2) times. This will bring up point one (1) of the throttle curve programming. The
current value is expressed, in percentage of the overall throttle travel, in the lower
right portion of the LCD.
2) Press the DATA INPUT lever upward to increase the percentage of servo travel for the respective point on
the throttle curve.
3) Press the SELECT button one time to bring up the point two (2) throttle curve adjustments. Again, use the
DATA INPUT lever to adjust the values accordingly.
4) Repeat the steps above as desired for the remaining three points on the throttle curve.
5) Press and hold the END button to exit the programming mode.
Pitch Curve (P-CV)- (ACRO only)
In addition to the throttle curve, the T6J also offers a pitch curve in the airplane functions. This will allow
modelers to utilize variable pitch propellers in their aircraft.