Futaba 6J 2.4GHz - Manual (Page 39)

39
Normal-
The T6J transmitter defaults to the normal wing type (non-selectable). If your model uses a single servo to
control the ailerons, there is nothing more to do. If, however, you are using separate servos to control each
aileron individually, please activate the Flaperon mixing. Information on how to do so is contained in the
section that follows.
Flaperon mixing (FLPR)- (ACRO only)
The ability to use separate servos to function in the same
PRYHPHQW GLUHFWLRQ WR FRQWURO WKH ÀDS GHÀHFWLRQ DQG WR ZRUN LQ
RSSRVLQJ GLUHFWLRQV DV DLOHURQV LV NQRZQ DV ÀDSHURQV $JDLQ WKLV
function allows the ailerons to be used both as ailerons and as
ÀDSV
Flap control is assigned to Channel 6, the proportional rotary knob on the front of the transmitter. As such,
LI ÀDSV DUH GHVLUHG &KDQQHO  PXVW EH XVHG DV WKH DGGLWLRQDO DLOHURQÀDS FKDQQHO $LOHURQV DUH FRQWUROOHG RI
course, by the aileron stick accordingly.
Note: A trim input on the aileron channel will move the two wing servos in the opposite direction. If so
desired, sub-trim must be input for the two wing servos individually as it impacts the servos rather than their
function.
7R DFWLYDWH ÀDSHURQ PL[LQJ ZLWK ÀDSV
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the flaperon (FLPR) wing menu
appears on screen.
4) Push the DATA INPUT lever upward for approximately two (2) seconds. This will
FDXVH WKH ,1+ GLVSOD\ WR ÀDVK UDSLGO\ EHIRUH FKDQJLQJ WR D ÀDVKLQJ 21 GLVSOD\
Note: <RX FDQQRW VHW ³)ODSHURQ´ PL[LQJ ZKHQ ³(OHYRQ´ PL[LQJ KDV DOUHDG\ EHHQ VHW ,Q RUGHU WR HQDEOH
³)ODSHURQ´ PL[LQJ \RX ¿UVW QHHG WR FDQFHO ³(OHYRQ´ PL[LQJ +RZHYHU LW LV DOORZHG WR XVH ³)ODSHURQ´ DQG
³9WDLO´ PL[LQJ VLPXOWDQHRXVO\
5) Connect the aileron servo in the right wing to channel 1 (aileron) in the receiver and connect the aileron
VHUYR LQ WKH OHIW ZLQJ WR FKDQQHO  ÀDSV LQ WKH UHFHLYHU
*If necessar y, use the Ser vo Reversing
function to achieve the correct direction of
servo throws.