Futaba 6J 2.4GHz User Manual

Page 57

Advertising
background image

57

12) Press and hold the END button to exit the programming mode.

Swash to throttle mixing (SW-T)-(HELI only)

When idle up is activated, this predetermined mixing function is used to prevent the engine from slowing, or
ERJJLQJ GRZQ ZKHQ VZDVKSODWH LQSXWV DUH JLYHQ VSHFL¿FDOO\ DLOHURQ RU HOHYDWRU FRQWUROV 7KLV IHDWXUH WDNHV
D ELW RI ÀLJKW WHVWLQJ WR VHW FRUUHFWO\

To activate swash to throttle mixing:

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode. An audible double beep will be heard

and the default screen will change.

3) Press either the MODE key OR the END key to scroll through the function menus.

Continue pressing the MODE or END key until the swashplate to throttle (SW-T)
mixing menu appears on screen.

4) Press the SELECT key to display the CH-A. This indicates that the values which

will be adjusted are the values of the aileron input.

5) Press the DATA INPUT lever to set the percentage of aileron to throttle mixing rate

from 0-100%.

6) Press the SELECT key to display the CH-E. This indicates that the values which

will be adjusted are the values of the elevator input.

7) Press the DATA INPUT lever to set the percentage of elevator to throttle mixing

rate from 0-100%.

5) Press the SELECT key to display the CH-4. This indicates that the values which will be adjusted are the

values of the rudder input.

6) Press the DATA INPUT lever to set the percentage of elevator to throttle mixing rate from -100% to

 

Swash Ring (RING)-

7KH 6ZDVK 5LQJ 5,1* IXQFWLRQ OLPLWV WKH VZDVK WUDYHO WR D ¿[HG UDQJH LQ RUGHU WR SUHYHQW GDPDJLQJ WKH
swash linkages from simultaneous operation of the aileron and elevator inputs. That is, this is basically an
electronic version of a former mechanical action that prevented binding of the controls when the elevator/

Advertising