Futaba 6J 2.4GHz - Manual (Page 27)

27
the DATA INPUT lever upward. The OFF indication will begin to blink rapidly and will soon change to
display ON.
5) Press and hold the END button to exit the programming menu.
Servo Reversing (REVR)-
The servo reversing function is used to change the direction that a servo responds to a control input from
the transmitter (stick or switch). After using the reversing function, check all the controls on the model to
be certain they are operating in the correct direction and that you did not inadvertently reverse a servo other
than the one intended. Reversing the wrong servo (and not checking the response of the controls before each
ÀLJKW PD\ EH WKH PRVW FRPPRQ FDXVH RI D FUDVK
Note: Reversing the throw of a servo channel will affect all mixings, etc. that interact with this channel. For
H[DPSOH LI WKH DLOHURQ VHUYR LV UHYHUVHG WKH DLOHURQ VHUYR¶V WUDYHO GLUHFWLRQ ZLOO DOVR EH UHYHUVHG LQ ÀDSHURQV
(if active). As such, we strongly suggest adjusting the servo reversing as one of the earliest steps in the
programming of the T6J.
To reverse a servo:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the reverse (REVR) menu appears
on screen.
4) Press the SELECT key to select the channel you wish to reverse.
5) Push the DATA INPUT lever downward for 0.5 seconds to reverse (REV) the servo. Press the DATA
INPUT lever upward for 0.5 seconds to make the servo operate in a normal (NOR) direction.
6) Repeat the steps above to bring forth and modify any other channels for which the travel direction is to be
altered.
7) Press and hold the END button to exit the servo reverse menu.