Futaba 6J 2.4GHz - Manual (Page 65)

65
To activate trainer function:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the trainer (TRNR) menu appears on
screen.
 7KH WUDLQHU PRGH LV FXUUHQWO\ LQKLELWHG ,1+  WKXV WKH ÀDVKLQJ ,1+ RQ WKH /&'
screen. Press and hold the DATA INPUT lever upward for approximately two (2)
VHFRQGV 7KH 7-¶V WUDLQHU IXQFWLRQ ZLOO EH DFWLYDWHG DV LQGLFDWHG E\ WKH 21 DQG WKH
audible beep.
5) Follow the procedure below to program the desired trainer mode selection for the T6J.
Trainer mode selection:
As noted previously, there are several trainer modes available in the T6J. The methodology utilized will vary
IURP LQVWUXFWRU WR LQVWUXFWRU DQG ZLOO DOVR YDU\ GHSHQGLQJ XSRQ WKH VWXGHQW¶V DELOLW\ DV ZHOO &KDQQHOV 
offer three different modes; Channels 5 and 6 offer two. Each channel may be individually assigned using
one of the trainer modes. The trainer modes are as follows:
1RUPDO 125 7KH PRGHO LV FRQWUROOHG E\ WKH VLJQDOV IURP WKH VWXGHQW¶V WUDQVPLWWHU 7KH 1RUPDO PRGH LV
offered on all six (6) channels of the T6J.
)XQFWLRQ )81& 0RGH 7KH PRGHO LV FRQWUROOHG E\ VLJQDOV IURP WKH VWXGHQW¶V
WUDQVPLWWHU XVLQJ WKH LQVWUXFWRU¶V VHWWLQJV 1RWH ,I XVLQJ WKLV PHWKRGRORJ\ SOHDVH
VHW WKH VWXGHQW¶V WUDQVPLWWHU WR WKH GHIDXOW VHWWLQJV 7KLV ZLOO SUHYHQW DQ\ LVVXHV WKDW
might otherwise arise with varying control inputs. The Function mode is only offered
on Channels 1-4 of the T6J.
2II 2)) 7KH LQVWUXFWRU¶V WUDQVPLWWHU ZLOO SURYLGH WKH LQSXW IRU WKH UHVSHFWLYH FKDQQHO 7KH 2II PRGH LV
offered on all six (6) channels of the T6J.
1) With the trainer function active, press the SELECT button to choose the desired channel.
2) Press the DATA INPUT lever either upward or downward to select amongst the available trainer modes for
the previously selected channel.
3) Repeat this for all other channels as desired.