Futaba 6J 2.4GHz - Manual (Page 54)

54
6) Press the SELECT button to bring up the point two (2) pitch curve adjustments. Again, use the DATA
INPUT lever to adjust the values accordingly.
7) Repeat the steps above as desired for the remaining three points on the pitch curve.
8) Press and hold the END button to exit the programming mode.
Revolution Mixing (REVO) - (HELI only)
5HYROXWLRQ PL[LQJ FRPPRQO\ UHIHUUHG WR DV ³5HYR´ PL[LQJ LV XVHG WR DGG UXGGHU LQSXWV LQ FRQMXQFWLRQ ZLWK
pitch inputs. This mixing assists in compensating for the rotation of the helicopter caused by the increased
torque. The T6J transmitter allows for a high rate and a low rate adjustment for the revolution mixing.
Note: If using a heading hold/AVCS gyro, only use the revolution mixing when this gyro is in the normal
mode. Do NOT use revolution mixing with a heading hold/AVCS gyro when it is in the heading-hold/AVCS
mode.
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the revolution mixing (REVO) menu
appears on screen.
4) The right side of the LCD should indicate that the revolution mixing is inhibited,
as denoted by the flashing INH. Activate the revolution mixing by pressing and
KROGLQJ WKH '$7$ ,1387 OHYHU XSZDUG 7KH ,1+ VKRXOG EHJLQ ÀDVKLQJ UDSLGO\
prior to changing to ON.
5) Push the SELECT key to bring up the low rate (as indicated by the down arrow on
the left side of the LCD screen).
6) To adjust the value, press the DATA INPUT lever either upward or downward until
the desired value is achieved.
7) Press the SELECT key once again to access the revo mixing adjustments for the high side. The up arrow
on the left side of the screen indicates that it is the high side that will be adjusted.
8) To adjust the value, press the DATA INPUT lever either upward or downward until the desired value is
achieved.