Futaba 6J 2.4GHz - Manual (Page 28)

28
Dual Rates/Exponential Settings-
Dual Rates/Exponential Settings vary slightly between the airplane (ACRO) mode and the helicopter (HELI)
mode. As such, the information pertaining to these functions will be separated into ACRO and HELI
sections below. Please adhere to the section that pertains to the model for which you are programming the
T6J transmitter.
ACRO Dual Rates/Exponential Information:
Dual Rates (ACRO):
&RPPRQO\ DEEUHYLDWHG DV ³'5´ GXDO UDWH LV WKH DELOLW\ WR FKDQJH WKH WUDYHO GLVWDQFH RI D VHUYR RU VHUYRV
affecting the overall travel of the servo(s). Thus, decreasing the percentage value for a given servo will
reduce the travel amount of the channel respectively.
For example, if the elevator of the aircraft travels 1/2” at the high rate and maximum stick input, and a value
of 50% is input for the low rate, when the switch is moved to the low rate position, the servo moves exactly
half as far per stick position. Following this example, if the elevator control input is all the way up, the
maximum travel is now 1/4”
The T6J transmitter offers dual rates on the aileron, elevator and rudder channels. The dual rates are
assignable to any of the switches on the transmitter and all are simultaneously activated by the dual rate
switch selected.
The amount of travel decrease for each control may be set between 0% and 140% of the values set for the
end points (explained in End Point Adjustment on page 33).
Note: It is possible to set a dual rate value to zero, thus causing no response from that channel when the dual
rates are activated. If the dual rates are inadvertently set to zero, a crash could result.
Note: :KHQ SHUIRUPLQJ WKH LQLWLDO PRGHO VHWXS WKH (3$¶V VKRXOG EH VHW SULRU WR VHWWLQJ WKH GXDO UDWHV :KHQ
VHWWLQJ WKH (3$¶V IRU WKH ¿UVW WLPH RQ D QHZ PRGHO WKH GXDO UDWHV VKRXOG EH VHW WR  
D/R Dual Rate Settings (ACRO)
To select the Switch/position to control the dual rates:
Prior to programming the dual rates for the aileron, elevator or rudder channels, we suggest selection of the
switch that will be utilized to control the rate settings.
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus. Each time one of the
aforementioned keys is pressed the menu will change accordingly. Continue pressing the MODE or END