Futaba 8UHFS, 8UHPS - Manual (Page 18)

15
When you first turn on your transmitter, a confirmation beep sounds, and the screen
shown below appears. Before flying, or even starting the engine, BE SURE that the
model name appearing on the display matches the model that you are about to fly! If
you don’t, servos may be reversed, and travels and trims will be wrong, leading to an
immediate crash.
(upper = first digit,
Current Screen Display
< > Normal screen
< = Advance menu screen
> = Basic Menu screen
Model Name
(to change, see p. 37)
Modulation
indicator
PCM shown
Current model memory
lower = second digit)
Model 01 shown
Elevator trim display
Throttle trim
display
Timer On/Off Indicator
(see P. 34 to set timer)
The timer appears if one
of the cursor keys is
pressed.
Rudder
trim
Aileron trim
Battery voltage
(Alarm goes off at 8.5 V)
Total timer display (hours:minutes)
Shows the cumulated ON time
Reset by pressing (+ )/(-) keys together
Note: trim display can be displayed in reverse video (see page 39)
DATA INPUT keys – use
these to input numbers or
settings
Press these two keys to
turn on Advance Menu
CURSOR keys – use to
select item to be set or
changed in the screen
MODE key – use to
select desired function
while programming
Press these two
keys to turn on
Basic Menu