Futaba 8UHFS, 8UHPS - Manual (Page 89)

85
Caution:
The relationship of the governor speed setting rS1~rS3 and the switch positions
conforms to the table above. Since the governor mixing function may not be used or
the direction may be different, if this mixing was turned ON, first check the direction.
At throttle hold, always check that the governor is OFF. Conversely, when the
speed value rises, reverse it as described in "Throttle hold OFF direction selection".
Setting the Governor Mixing Function
To TH-NDL
function
To GYRO
function
Switch
direction
display
Data input keys
These keys are used to move
around in the GOVrpm menu.
2. “UP” Side Rate Setting:
Enter your desired speed value
with the (+)/(-) keys.
3. “CNTR” :
Enter your desired speed value
with the (+)/(-) keys.
4. “DOWN”:
Enter your desired speed value
with the (+)/(-) keys.
Switch C: UP, CNTR, DOWN
Switch G: NORM, IDL1,IDL2
Speed setting
Range: 0 to 100%
(Initial value:
UP=0%
CNTR=50%
DOWN=100%)
1. Activate Governor Mixing Function
Press the (+) key to activate the GOVrpm function.
( Use the (-) key to INHibit the mixer.)
Channel setting
Range: CH7 or CH8
5. ON/OFF Channel Selection
Select the output channel with
the (+)/(-) keys.
CH7: CH7 controls the speed and ON/OFF.
CH8: CH8 independently controls ON/OFF.
ON/OFF is performed with switch B.
Current setting
Range: lmt+, lmt-
6. Selection of OFF Direction at Throttle Hold
Operate the (+)/(-) keys in the direction that turns
the Governor off at throttle hold operation.
Switch display
Range: SW-C or SW-G
7. Switch Selection
Chose the desired mixer switch
with (+)/(-) keys.