Futaba 8UHFS, 8UHPS - Manual (Page 36)

32
The Engine Start function activate a switch which turns the (on-board) engine starter
on and off with switch H. The engine starter and snap roll functions cannot be used
simultaneously.
SETTING METHOD
To TRAINR function
Current setting display
(one of CH5, CH7, CH8
or INH). The default
setting is INH (inhibited).
EG/S Control channel setting:
Select the starter control
channel with the (+)/(-) keys.
To REVERS function Data input keys
These keys are used to move through submenus in the PARA function.
This function is used to select the type of model to be programmed in the current
model memory. You may select from aircraft (ACRO), gliders with one or two flap
servos (GLID1FLP, GLID2FLP), and helicopters of five swash types
(HELISWH1/SWH2/SWH4/SR-3/SN-3).
Swashplate Type Setting Procedure
HELISWH1 Type
This type’s helicopter has independent aileron and elevator servos linked to the
swashplate. Most kits are HELISWH1 type.
HELI SWH2 Type
Use SWH2 mixing when the pushrods are
positioned as shown in the figure. Elevator
operates with a mechanical linkage.
Pitch Aileron
Front
With Aileron inputs, the aileron and pitch servos
tilt the swashplate left and right;
With Pitch inputs, the aileron and pitch servos
raise the swashplate up and down.
HELI SWH4 Type
If the servo inputs are located as shown, use SWH4
Mixing.
Aileron Pitch
Front
(Pitch) (Aileron)
Elevator 1
Elevator 2
(CH8)
With Aileron inputs, the aileron and pitch servos
tilt the swashplate left and right;
With Elevator inputs, the servos tilt the swashplate
fore and aft;
With Pitch inputs, all four servos raise the
swashplate up and down.