Futaba 8UHFS, 8UHPS User Manual

Page 73

Advertising
background image

69

for aileron, elevator, and rudder. The delays you
set apply to all flight conditions. We recommend
trying very small values for the initial settings, say
5 - 10%. A 25% delay is about a half-second
transit time between neutral settings.

You may use the Hovering Pitch and

Hovering Throttle functions for fine trimming
changes due to humidity, etc.

This concludes the example setup procedure

for helicopters. Be sure to browse through the
pages following this example to see what other
menus are available for helicopters, such as
Hovering Throttle and Pitch knobs, OFST, ACC,
DELAY, and INVERT CROSS. You may use a
mixer to adjust gyro sensitivity, or to enhance
flight capabilities or to correct a response you
don’t like. Again, we recommend you set up and
trim in the Normal flight condition before setting
up the alternate flight modes.

This procedure assumes helicopter is trimmed for hovering. Trimming must be done

in near-calm conditions. Repeat tests several times before making adjustments. If any
changes are made, go back over the previous steps and verify, or further adjust as necessary.

To test _

Test Procedure

Observations

Adjustments

1. Revo
mixing — Up
settings (Part 1)

Fly the model straight
and level into the wind
at 100 ft altitude, lower
pitch to 0°

Observe rotation as copter

descends


A. No rotation
B. Model rotates

counterclockwise

C. Model rotates clockwise




A. None
B. Add right rudder

trim

C. Add left rudder

trim

2. Revo
mixing — Up
settings (Part 2)

Bring the copter into
hover, add full pitch and
ascend 75 ft

Observe rotation as copter

ascends


A. No rotation
B. Model rotates

counterclockwise

C. Model rotates clockwise




A. None
B. Increase UP revo

mix

C. Decrease UP revo

mix

3. Revo Down
mixing settings

Begin Down Revo
mixing with same
number as UP mix.
From inverted flight (top
of loop, or mid-point of
roll, or inverted part of
split-S), add full
negative pitch

Observe rotation as copter

ascends


A. No rotation
B. Model rotates clockwise
C. Model rotates

counterclockwise



A. No adjustment
B. Increase Down

revo mix

C. Decrease Down

revo mix


Advertising
This manual is related to the following products: