Futaba 8UHFS, 8UHPS - Manual (Page 82)

78
Inputting the Throttle Curve in Normal, Idle-up 1, and Idle-up 2
CAUTION
Before actually starting the engine, be sure that idle-up switches 1 and 2 are off, and the
throttle is set near engine idle.
To TH-CRV
IDL1 function
To PI-CRV
NORM function Data input keys
These keys are used
to move through the
five submenus in the
TH-CRV function.
The bottom arrow shows the point
on the five-point curve currently
being set.
Top arrow indicates the current stick
position (2 arrows means it's between
points)
Curve points 1-5
Curve Name
Display
(NORM)
Input 5-point curve values
Move the lower arrow to the
position you want to set with the
CURSOR keys (the curve point is
indicated by the arrow below the
numbers 1-5, and the current
throttle position is above the
numbers). Enter the desired curve
value with the (+)/(-) keys.
• If you're unhappy with what you've
set, you may return to the default
value by pressing the (+) and (-)
keys simultaneously.
Curve Point Value
(Range: 0 - +100%)
Initial curve settings:
POS1 = 0%
POS2 = 25%
POS3 = 50%
POS4 = 75%
POS5 = 100%
The Throttle Curve Normal function is on at startup.
The blinking item on the
setting screen is the
current setting item.
Idle-up 1 Curve Setting
The TH-CRV IDL1 function will not operate until the OFST1
function is activated. This also activates the IDL1 Pitch &
REVOLU curve menus. You can activate idle-up 1 and idle-up 2
independently.
The curve setting procedure is the same as normal curve
described above.
To TH-CRV IDL2 function
To TH-CRV function
Idle-up 2 Curve Setting
The TH-CRV IDL2 function will not operate until the OFST2
function is activated. This also activates the IDL2 Pitch &
REVOLU curve menus.
The curve setting procedure is the same as normal curve
described above.
You can activate idle-up 1 and idle-up 2 setups independently. To TH-HLD function
To TH-CRV IDL1 function