Futaba 8UHFS, 8UHPS - Manual (Page 30)

27
Setting Dual Rate Values and Switches
Channel display: AI = Aileron,
EL = Elevator, RU = Rudder
To EXP
function
To ATV function
Range: 30 - 140%.
Initial value=100%
*The blinking item is what is
being set.
Data input keys
These keys are used to move
through items 1-6 in this menu.
1. Aileron adjustment: place the
aileron D/R switch and stick in the
set the rate with the (+)/(-) keys.
2. Elevator: place the elevator D/R
switch and stick in the direction
the (+)/(-) keys.
3. Rudder: put the rudder D/R
switch and stick in the direction
the (+)/(-) keys.
• If you're unhappy with your set
value, you may return to the default
value by pressing the (+) and (-)
keys simultaneously.
You may wish to select "STK-x" when
you want to have the dual rate turn
on and off according to the position of
the stick. This is effective during
stall turns and other maneuvers.
After you have selected the "STK-x"
menu, hold the stick at the position
you wish to switch dual rates.
Next, store the position by pressing
the (+) and (-) keys simultaneously.
This will change the stick position
blinking numbers. Check that the
dual rate is switching by moving the
stick. The little arrow should move
from one side to the other.
4. Select Aileron D/R switch
with the (+)/(-) keys.
5. Select the Elevator D/R
switch with the (+)/(-) keys.
6. Select the Rudder D/R
switch with the (+)/(-) keys.
You can put all three rates on a
single switch.
See notes to right about stick
switch setting.
Channel display
D/R switch display
(SW-A, SW-B, SW-D, SW-E for
helicopters, STK-1, STK-2,
STK-3, STK-4)
Indicates top or bottom
switch position (top shown)
(The value of the stick adjusted
by stick operation blinks.)
you want to set and adjust with
direction you want to adjust and
you want to adjust and set with
STK-1:Aileron stick
STK-2:Elevator stick
STK-3:Throttle stick
STK-4:Rudder stick
(STK-1/STK-2/STK-4)
100% 90% 0% 90%100%
stick operation
B rate A rate B rate
(STK-3)
0% 30% 100%
stick operation
B rate A rate