Futaba 8UHFS, 8UHPS - Manual (Page 56)

52
The pages in the glider section describe the additional special mixing
functions that only are available when the two glider (GLID1FLP, GLID2FLP) model
types are selected. The GLID1FLP menu is intended for sailplanes with one or two
aileron servos, and a single flap servo (or two connected with a y-connector), while
the -2FLP configuration is for dual flap servos that can act oppositely as ailerons.
Note that for some aerobatic and slope gliders, the ACRO menus may be more
appropriate to use, as they provide snap rolls.
For an explanation of the other Advance Menu functions available in the GLID
menus, refer to the aircraft (ACRO) Advance Menu section, p. 43 to 51.
If you wish to have the three-position switch controlling Normal, Start, and Speed
on the left-hand side of the transmitter, you should purchase the 8UH Helicopter
system. The 8UA system places it on the right-hand side.
Glider Functions Map....................................................53
GLID-2FLP Setup Example ..........................................54-57
Sailplane Trimming Chart .............................................57-58
BFLY............Butterfly
mixing......................................59
FLP
→AI.......Flap→aileron mixing..............................60
AIL
→FL.......Aileron→flap mixing..............................61
START .........START (launch) presets .........................62
SPEED..........Speed presets ..........................................63
CH1
CH2
CH4
CH6
CH6
CH7
Glider 1FLP Configuration
CH1
CH2
CH4
CH5
CH6
CH7
Glider 2FLP Configuration