Examples of these four curves are shown below – Futaba 8UHFS, 8UHPS User Manual

Page 93

Advertising
background image

89

The pitch curve is defined by a 5-point curve so that you may set the best pitch motion

relative to throttle stick movement. Each point on the curve can be adjusted over a 0% to
100% range.

The T8U system contains five pitch curves: normal (NORM), idle-up 1 (IDL1), idle-up 2

(IDL2), hold (HOLD), and inverted (INVR). The basic normal pitch curve is the only one
displayed in the Basic Menu, but all of the pitch curves can be viewed in the Advance menu.
The Normal curve is exactly the same in both the Advance and Basic Menus.

Use the idle-up switch (switch G) to move between Normal, idle-up 1, and idle-up 2.

(The PI-CURV functions for IDL1 and IDL2 curves will not operate until the OFST-1 and
OFST-2 functions are activated.) Switching to the hold (HOLD) function is performed with
switch E. Switching to the inverted (INVR) function is performed with switch H. Note
that whenever the hold switch is turned on, it has priority regardless of the idle-up switch

osition.

p

The normal (NORM) pitch curve function produces the basic pitch curve for flight near

hover. It is set up to provide up and down control at a constant engine speed along with the

ormal throttle curve.

n

The HI-side pitch curve limits the maximum rotor pitch so that a large load is not applied

to the engine. The LO-side pitch curve produces a curve with a minimum pitch of -4°.
Idle-up 1 is used for 540° stall turns, looping, and rolling stall turns, while idle-up 2 is used

or rolls.

f

The throttle hold curve is used when performing autorotations, and should provide pitch

from -4° to +12°. To get this pitch range, set the HI and LO rates to +100% and -100%
respectively.

Examples of these four curves are shown below:

NORM Pitch Curve Example

Servo Response

IDL2 Pitch Curve Example

Servo Response

HOLD Pitch Curve Example

Servo Response

IDL1 Pitch Curve Example

100%

75%

50%

25%

0%

100%

75%

50%

25%

0%

100%

75%

50%

25%

0%

LOW

← throttle stick → HI

100%

75%

50%

25%

0%

Servo Response

1

2

3

4

5

Curve Point

70%

55%

30%

17%

90%

7%

28%

40%

57%

68%

10%

27%

43%

58%

70%

LOW

← throttle stick → HI

1

2

3

4

5

Curve Point

LOW

← throttle stick → HI

1

2

3

4

5

Curve Point

LOW

← throttle stick → HI

1

2

3

4

5

Curve Point

Advertising
This manual is related to the following products: